Core I/O Leds; Figure 5-7. Core I/O Card Bulkhead Leds - HP Integrity rx8620 User's & Service Manual

Troubleshooting
HP Integrity rx8620 Server LED Indicators

Core I/O LEDs

The core I/O LEDs in Table 5-7 on page 115 are located on the bulkhead of the installed core I/O PCA. There
is a DIP switch on the core I/O card that is used to select which MP firmware set (indicated by the MP SEL
LED) is selected for loading. The DIP switch is only visible when the core I/O card is removed from the system
and is located in the center of the PCA.
Figure 5-7 Core I/O Card Bulkhead LEDs
114
ATTN
PWR
SCSI TRM
SCSI LVD
SYS LAN LINK (located on edge of SYS LAN Connector)
SYS LAN FDUP
SYS LAN 1Gb
SYS LAN 100 BT
SYS LAN 10 BT
SYS LAN ACT (located on edge of SYS LAN Connector)
MP LAN LINK (located on edge of MP LAN Connector)
MP LAN 100 BT
MP LAN 10 BT
MP LAN ACT (located on edge of MP LAN Connector)
MP FAULT
MP SEL
ACTIVE
MP PWR
Chapter 5