Advertisement
PA-W1400
[Fig. 6-11]
PAPER HOLDER:
Front
Rear
'Screws:
Hammer plate
Screwdriver
IFig. 6-12]
[Fig. 6-9]
PLATEN sete
Parallel to the platen roller
Pe
\
a
ae
oe
|
~ PRINT WHEEL
CORRECTABLE
RIBBON
IFig. 6-10]
6-5. Hammer height adjustment
[Fig. 6-13]
(1) Make copy samples of repeated capital "H" using pressure-set
x The screw tightening torque must be 9kg-cm.
copy paper, carbon copy paper, and non-carbon copy paper.
(2) If printed image is weak at one side (Fig. 6-11), loosen the
screw as shown in Fig. 6-12 and adjust the hammer plate posi-
tion to obtain the character typed even between top and bottom.
Advertisement
