Advertisement
PA-W1400
% Reference to Fig. 5-19, Fig. 5-26.
To replace the ribbon holder unit to the carriage base, the pin
will automatically lock when the reverse sequence of the dis-
assembly is done (D, B), in case the cam is on its home
position (print standby position). If it is on the correct position,
it will need to do the reverse sequence of (D), (B), and (A). If
the pin should rest over the cam where not slit is, it may lock.
OK
NG
In this case, manually rotate the cam or make sure that the
pin is completely engaged in the slit.
[Fig. 5-26]
8-4. Motor plate unit (Fig. 5-27)
(3) Remove the ribbon holder unit.
Disassembly procedure
For details, refer to paragraph 8-3, Ribbon holder unit.
i
-
(4) Pull out the wheel release lever @ in the arrow direction (A).
(1) Remove the mechanical unit.
(
J
:
/
( A ) .
i
7
ae
It will come out easily when pushed up with your fingertips Fig.
For details, reer
paragraph [5]-5. Mechanical unit.
5-28,
@ porate, ne Ranlege 'unit Pet details, relec ie paragraph B:4:
(6) Remove two screws (B1) that hold the card holder ©, then
's
i
remove the card holder ©.
IFig. 5-27]
Inset the top end (J) of the relase ledge @ to this location of the
carriage
base.
-
IFig. 5-29]
®
-
©—-7
[Fig. 5-28]
5-10
{Fig. 5-30]
Advertisement
