Advertisement
PA-W1400
(5)
Unfasten the 6 pin RF motor connector ® which connects the
(7)
Remove the ribbon motor.
carriage base unit with the ribbon holder unit.
(8) Remove the idle gear unit. See Fig. 5-23 for disassembly and
(6)
Remove the cam unit © (3 E-rings).
re-assembly.
x See Fig. 5-21 for disassembly and re-assembly of the cam
4 (6) L =
|
E-Ring
ce
®
[Fig. 5-20]
J
dl
&
By
(9) Push the ribbon takeup knob in the arrow direction and remove
it. Note that the RF-ratchet and the RF-drive gear will come
away.
(10) To remove the tape holder (R, L), push the end of the shaft in
the arrowhead (G) and remove it, with a minimum distance of
pushing to avoid possible breakage in the shaft.
To re-assemble, simply push it in until it locks.
Observe the reverse sequence of the disassembly procedure,
with attention to the following.
(a) Because there are two kinds of rift-off tape holders, L and R,
they must be installed in their proper location. They can be
identified by the size and shape of the teeth. (See Fig. 5-25)
Tape holder F
TFig. 5-25]
Advertisement
