Advertisement
PA-W1400
8-2. Carriage unit
Disassembly procedure
(ly
Remove tte Wiealaaiey ied
(4)
Move the carriage (3) to the left side.
'or d e t a i l s , refer
to para,
5]-5.
ical
unit.
hs
i
i l s , refer to paragraph [5}-5. Mechanical unit.
(S) While pushing the slide shaft @ to the left (arrowhead A), pull
(2) Remove the PF holder screw @ on the left side of the mechani-
out the right side of the shaft from the mechanical frame @ in
cal frame ®.
the arrowhead B, then remove the carriage @.
(3)
Remove the belt in the arrow direction from the timing belt junc-
Reassembly procedure
tion on the back of the carriage unit. If there was any difficulty,
loosen the carriage motor frame holding screw and somewhat
release the belt tension.
Observe the release sequence of the disassembly procedure.
IFig. 5-15]
NOTE
1) Avoid separating the carriage cable © from the main
frame as much as situation allows. It will weaken the
bonding strength of the double tack tape (Fig. 5-18 -
When reassembling, make sure that the slide shaft @ is
firmly engaged in the slit of the PF holder © (Fig. 5-16)
Note the installing direction of the slide shaft @. The side
with the ledge must be on the right side as shown
in (D)
in Fig. 5-15.
4) When
reassembling the carriage unit @
to the main
frame, move the carriage unit @ all the way to the left in
reference to the frame, insert the slide shaft, thenirstall it
'on the mechanical frame. The tab (E) must be isserted
from the arrow direction (G) so that it should engage in
the mesh part (F) of the mechanical frame.
2)
&
Advertisement
