Table of Contents
Advertisement
3.
Install the Expansion card riser
4.
Install the drive
cage.
5. Install the
2U air
shroud.
6. Follow the procedure listed in
7. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing a faulty storage controller or NIC card or GPU with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more information
about the Part replacement configuration, see the Dell Lifecycle Controller User's Guide available at
idracmanuals
CAUTION:
Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
Side wall brackets
Removing the side wall bracket
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
NOTE:
The procedure to remove the side wall bracket is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Press the side tabs to release the side wall cable holder.
NOTE:
Move the cables out of the side wall cable holder.
2. Press the center tab to release the bracket from the chassis, and lift it away from the system.
144
Installing and removing system components
2.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
https://www.dell.com/
Advertisement
Table of Contents
