Table of Contents
Advertisement
m. Disconnect all the cables from the system board and make note of all the cable connections.
CAUTION:
Take care not to damage the system identification button while removing the system board
from the system.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
NOTE:
The procedure to remove the system board is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Using the Phillips 2 screwdriver, loosen the two thumbscrews and lift the metallic bar away from the system.
2. Using the Phillips 2 screwdriver, loosen the thumbscrew on the system board.
3. Using the system board holder, slide the system board towards the front of the system.
4. At a tilted angle, lift the system board out of the chassis.
Figure 161. Removing the system board
Next steps
1.
Install the system
board.
Installing the system board
Prerequisites
NOTE:
Before replacing the system board, replace the old iDRAC MAC address label on the Express Service Tag with the
iDRAC MAC address label of the replacement system board.
Installing and removing system components
185
Advertisement
Table of Contents
