Table of Contents
Advertisement
CAUTION:
Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
NOTE:
The procedure to install the Expansion card riser 2 is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Holding the edges, align the expansion card riser with the guides on the system board. Lower the expansion card riser into
place and connect the riser cables to the signal cable connectors on the system board.
2. Using the Philips 2 screwdriver, tighten the blue thumb screws.
Figure 96. Installing the Expansion card riser 2
Next steps
1. If required, reconnect the cables to the expansion card or system board.
2.
Install the drive
cage.
3. Install the
2U air
shroud.
4. Follow the procedure listed in
5. Install any device drivers required for the card as described in the documentation for the card.
Removing the Expansion card riser 1
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4.
Remove the drive cage
5. Remove the
Expansion card riser
6.
Remove the Expansion card riser
7. Disconnect the expansion card riser cables from the connectors on the system board routed under riser 3.
8. If applicable, disconnect the cables from the expansion card or system board.
128
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
2.
3.
system.
system.
Advertisement
Table of Contents
