Figure 142. Set the anti-tilt wires to the locked position and tightening the nuts
Next steps
1.
Install the 1U air
shroud.
2. Follow the procedure listed in the
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the power or data cables from the expansion cards.
4. if
installed,remove the riser
NOTE:
The procedure to install and remove the system battery is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
168
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
3.
system.
system.