Table of Contents
Advertisement
Figure 160. Installing the OCP card
Next steps
1.
Install the expansion card riser
2. Follow the procedure listed in
System board
This is a service technician replaceable part only.
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted
to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key.
If you replace this system board, you must supply the recovery key when you restart your system or program
before you can access the encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a.
2U Air shroud
b.
Expansion card risers
c.
1U Air shroud
d.
Front PERC
e.
Drives
f.
Drive cage
g.
Memory modules
h.
Processor and heat sink module
i.
BOSS-N1 riser
j.
Internal USB card (if installed)
k.
OCP card (if installed)
l.
Power supply units (PSU)
184
Installing and removing system components
3.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
