Table of Contents
Advertisement
Figure 99. Removing the expansion card riser 3
Next steps
1.
Replace the expansion card riser
Installing the expansion card riser 3
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4.
Remove the drive
cage.
5. Remove the
Expansion card riser
6. Remove the
Expansion card riser
7. If removed,
install the expansion cards into the expansion card
CAUTION:
Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
NOTE:
The procedure to install the riser 3 is the same for Rear Accessed and Front Accessed configurations.
Steps
Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board. Lower
the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the
system board connector. Using the Philips 2 screwdriver, tighten the blue thumb screw.
3.
Safety
instructions.
Before working inside your
2.
1.
system.
risers.
Installing and removing system components
131
Advertisement
Table of Contents
