Table of Contents
Advertisement
Figure 48. Installing the 1U air shroud
Next steps
1. If required, reconnect the cables to the expansion card or system board.
2.
Install the Expansion card riser
3.
Install the Expansion card riser
4.
Install the 2U air
shroud.
5. Follow the procedure listed in
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front bezel
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
Steps
Press the release button, and slide the drive blank out of the drive slot.
1.
2.
After working inside your
Safety
instructions.
system.
Installing and removing system components
87
Advertisement
Table of Contents
