Table of Contents
Advertisement
Table 4. Features available on the rear view of Rear Accessed configuration without bezel (continued)
Item
6
7
8
9
10
11
12
13
14
16
System overview
Ports, panels, or slots
Power supply unit (PSU 2)
and (PSU 1)
System identification button
VGA port
PCIe expansion card riser 3
(Low profile slot 5)
OCP NIC card (optional)
USB 2.0 port
USB 3.0 port
iDRAC dedicated port
2 x LOM ports
Icon
N/A
N/A
Description
Indicates the PSU2
(redundant PSU) and PSU1
(primary PSU)
Press the system ID button:
● To locate a particular
system within a rack.
● To turn the system ID on
or off.
To reset iDRAC, press and
hold the button for 16
seconds.
NOTE:
● To reset iDRAC using
system ID, ensure that
the system ID button is
enabled in the iDRAC
setup.
● If the system stops
responding during
POST, press and hold
the system ID button
(for more than five
seconds) to enter the
BIOS progress mode.
Enables you to connect a
display device to the system.
Enables you to connect PCI
Express expansion cards.
The OCP NIC card supports
OCP 3.0. The NIC ports are
integrated on the OCP card
which is connected to the
system board.
This port is USB 2.0-
compliant.
This port is USB 3.0-
compliant.
It is an RJ-45 port.
Enables you to remotely
access iDRAC. For more
information, see the
Integrated Dell Remote
Access Controller User's
Guide at
www.dell.com/
poweredgemanuals.
The LOM ports that are
integrated on the system
board provide network
connectivity. These LOM
ports can also be shared with
iDRAC when iDRAC network
settings is set to shared
mode.
Advertisement
Table of Contents
