Table of Contents
Advertisement
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the
drives.
4.
Remove the fPERC
module.
5.
Remove the drive
backplane.
NOTE:
Route the cables properly when you replace them to prevent the cable from being pinched or crimped.
NOTE:
The procedure to install the drive backplane is the same for Rear Accessed and Front Accessed configurations.
Steps
1. For 4 x 2.5-inch drive backplane, align the guide pins on the backplane with the guides on the system. Insert the backplane
into the guides and lower the backplane firmly until it is fully seated. Using the Phillip 2 screwdriver, tighten the blue thumb
screws on the drive cage.
Figure 71. Installing the 4 x 2.5-inch drive backplane
2. For the 8 x E3.S drive backplane, align the guide pins on the backplane with the guides on the system. Insert the backplane
into the guides and slide the backplane module toward the drives until it is fully seated. Using the Phillip 2 screwdriver,
tighten the metallic thumb screws on the drive cage.
102
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
