Table of Contents
Advertisement
Figure 123. Removing the BOSS riser
Next steps
1.
Replace the BOSS
riser.
Installing BOSS riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4. If installed, remove the
5. If installed,
remove the Expansion card riser
Steps
1. Holding the blue touch points, align the hole on the BOSS riser with the guide and connector on the system board.
2. Lower the BOSS riser into place and press until the BOSS riser connector is fully seated on the system board connector.
Safety
instructions.
Before working inside your
Expansion card riser
2.
1.
system.
Installing and removing system components
151
Advertisement
Table of Contents
