Table of Contents
Advertisement
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable, disconnect the cables from the expansion card.
NOTE:
The procedure to remove the T4 GPU card and the expansion card is the same.
Steps
1. Pull and lift up the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 58. Removing an expansion card from the low profile left riser
Safety
instructions.
Before working inside your
system.
Installing and removing system components
67
Advertisement
Table of Contents
