Table of Contents
Advertisement
2. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
The procedure to remove the expansion card from the risers 1A (slot 1), 1B (slot 1), 4A (slot 4), 4B (slot 4) is same. The
procedure to remove the expansion card from the risers 1A (slot 2), 1B (slot 2), 4A (slot 3), 4B (slot 3) is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the cables from the expansion card.
4.
Remove the expansion card
Steps
1. Pull the black card holder before removing the card from the riser. Pull and lift the expansion card retention latch lock to
open. Hold the expansion card by the edges, and pull the card until the card edge connector disengages from the expansion
card connector on the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 109. Removing expansion card from riser
2. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
Figure 110. Installing the filler bracket for the riser
130
Installing and removing system components
Safety
instructions.
Before working inside your
riser.
system.
Advertisement
Table of Contents
