Ieee 802.11 Specifications; Management And Monitoring Capabilities; Http/Https Interface; Command Line Interface - Proxim AP-4000 User Manual

Introduction

IEEE 802.11 Specifications

• In countries that require passive scanning for Mesh, the roam time may be higher.
• When an AP-4000M/4900M is mounted in a vehicle and is being used in a Mesh network, there will be limited
connectivity when the vehicle is moving.
IEEE 802.11 Specifications
In 1997, the Institute of Electrical and Electronics Engineers (IEEE) adopted the 802.11 standard for wireless devices
operating in the 2.4 GHz frequency band. This standard includes provisions for three radio technologies: direct sequence
spread spectrum, frequency hopping spread spectrum, and infrared. Devices that comply with the 802.11 standard
operate at a data rate of either 1 or 2 Megabits per second (Mbits/sec).
In 1999, the IEEE modified the 802.11 standard to support direct sequence devices that can operate at speeds of up to
11 Mbits/sec. The IEEE ratified this standard as 802.11b. 802.11b devices are backwards compatible with 2.4 GHz
802.11 direct sequence devices (that operate at 1 or 2 Mbits/sec). Available Frequency Channels vary by regulatory
domain and/or country. See
Also in 1999, the IEEE modified the 802.11 standard to support devices operating in the 5 GHz frequency band. This
standard is referred to as 802.11a. 802.11a devices are not compatible with 2.4 GHz 802.11 or 802.11b devices. 802.11a
radios use a radio technology called Orthogonal Frequency Division Multiplexing (OFDM) to achieve data rates of up to
54 Mbits/sec. Available Frequency Channels vary by regulatory domain and/or country. See
details.
In 2003, the IEEE introduced the 802.11g standard. 802.11g devices operate in the 2.4 GHz frequency band using
OFDM to achieve data rates of up to 54 Mbits/sec. In addition, 802.11g devices are backwards compatible with 802.11b
devices. Available Frequency Channels vary by regulatory domain and/or country. See

Management and Monitoring Capabilities

There are several management and monitoring interfaces available to the network administrator to configure and
manage an AP on the network:
•

HTTP/HTTPS Interface

•

Command Line Interface

• SNMP Management
• SSH (Secure Shell) Management
HTTP/HTTPS Interface
The HTTP Interface (Web browser Interface) provides easy access to configuration settings and network statistics from
any computer on the network. You can access the HTTP Interface over your LAN (switch, hub, etc.), over the Internet, or
with a "crossover" Ethernet cable connected directly to your computer's Ethernet Port.
HTTPS provides an HTTP connection over a Secure Socket Layer. HTTPS is one of three available secure management
options on the AP; the other secure management options are SNMPv3 and SSH. Enabling HTTPS allows the user to
access the AP in a secure fashion using Secure Socket Layer (SSL) over port 443. The AP supports SSLv3 with a 128-bit
encryption certificate maintained by the AP for secure communications between the AP and the HTTP client. All
communications are encrypted using the server and the client-side certificate.
The AP comes pre-installed with all required SSL files: default certificate, private key and SSL Certificate Passphrase
installed.
Command Line Interface
The Command Line Interface (CLI) is a text-based configuration utility that supports a set of keyboard commands and
parameters to configure and manage an AP.
Available Channels for details.
AP-4000 Series User Guide
Available Channels
Available Channels for details.
for
15