Configure Parameters; Figure 4-6: Configure The Ip Address Of Cu - Baicells Aurora243 Installation Manual

Aurora243 Outdoor 2x10W TDD gNodeB Installation Guide

4.1.5 Configure Parameters

After upgrading the gNB to the recent firmware version, log in to the gNB GUI and configure related
parameters to bring up the gNB online.
4.1.5.1 Configure CU and DU IP Addresses
Configure the CU and DU loopback IP address as 127.0.0.X. The NGAP Local IP and Egtpu Local IP of
the CU should be the same network segment as the AMF IP of the core network.
1. Go to NR Setting > Advanced. Then, under the CU pane, configure the CU IP address.
2. Configure the loopback IP address of CU in the F1ap Local IP and F1U IP field as 127.0.0.X.
3. Click the + Add icon in the AMF IP field to enter the AMF IP address and the NGAP Local IP address.

Figure 4-6: Configure the IP address of CU

4. Go to NR Setting > Advanced. Click the DU pane to open the fields and configure the DU IP address.
5. Enter the loopback IP address of the CU in the DU F1C Remote IP field.
6. Enter the loopback IP address of DU in the DU F1AP Local IP and DU F1U Local IP fields.
7. Click the Save button.
34