Table of Contents
Advertisement
Aurora243 Outdoor 2x10W TDD gNodeB Installation Guide
Table 2-3: LEDs
LED
Color
PWR
Green
RUN
Green
ACT
Green
ALM
Red
Table 2-4: Interfaces
Interface Name
Description
PWR
Power interface: The gNB supports AC or DC power supply.
AC: 90 VAC to 264 VAC, nominal voltage 110/220 VAC
DC: -40 VDC to -57 VDC, nominal -48 VDC
ETH
RJ-45 Ethernet interface, used for debugging or data backhaul
OPT
Optical backhaul interface to connect to the external transmission network
GPS
Port for external GPS antenna, N-female connector
ANT0
Port for antenna 0, N-female connector
ANT1
Port for antenna 1, N-female connector
2.3 Location and Environment
The Aurura243 can be installed on a pole or a wall. For the best signal coverage, place the gNB in an
unobstructed location. In addition to network planning, when determining where to place the gNB,
you need to consider factors such as climate, hydrology, geology, the possibility of earthquakes,
reliable electric power, and transportation access. Avoid locating the gNB in areas with extreme
temperatures, harmful gases, unstable voltages, volatile vibrations, loud noises, flames, explosives, or
electromagnetic interference (e.g., large radar stations and transformer substations). In addition,
avoid areas prone to impounded water, soaking, leakage, or condensation. Environmental
specifications are shown in Table 2-5.
Status
Steady ON
OFF
Steady ON
Fast flash: 0.12 s on, 0.125s off
Slow flash: 1s on, 1s off
OFF
Steady ON
Slow flash: 1 s on, 1 s off
Steady ON
OFF
12
Description
Power is ON
No power supply
The power input is normal
The device is powering up
The device is operating normally
No power input or faulty board
The cell is active
The cell is inactive
Hardware alarm, for example, VSWR alarm
No alarm
Advertisement
Table of Contents
