Table of Contents
Advertisement
Aurora243 Outdoor 2x10W TDD gNodeB Installation Guide
3.4.4 Connect Optical Fiber Cable
1. Unscrew the screws on the cover of the gNB wiring cavity using a Phillips-head screwdriver to
open the wiring cavity.
2. Connect the optical fiber to the OPT interface in the wiring cavity.
3. Lay the cable along the wire groove and stretch it out of the wiring cavity.
NOTE: Redundant optical fiber should be neatly wound.
4. Connect the other end of the optical fiber to the optical distribution frame.
3.4.5 Connect Ethernet Cable
1. Connect the Ethernet cable to the ETH interface in the wiring cavity.
2. Lay the Ethernet cable along the wire groove and stretch it out of the wiring cavity.
NOTE: Use hose sleeves to protect the network cables.
3. Connect the other end of the Ethernet cable to the customer network equipment.
Caution: To prevent damage to the device, you must connect the optical fiber
cable/Ethernet cable before connecting the power cable.
3.4.6 Connect Power Cable
The power cable must meet the following requirements:
•
Install an air switch, socket switch, or plug with a fuse in the distribution box for lightning and
leakage protection.
•
Use a hose sleeve or wiring tube to protect the power cable.
•
Ground and weatherproof the distribution box for lightning and leakage protection.
•
The length of the DC or AC power cord must be less than 328 ft (100 m).
Since the length of cable needed for the power supply varies from site to site, the two ends of the power
adaptor are bare terminal ends. The installer would need to make the power cable according to the actual
measurements of the installation site. You will need to assemble the power plug and power terminal on
the two ends of the power adaptor.
Strip 0.47 in (12 mm) insulating layer with a wire stripper to connect to the conductor.
The steps for assembling the power cable are as follows:
1. Assemble the power plug on the power cable.
NOTE: The gNB supports DC or AC power supply. Therefore, the installer should select the
appropriate power supply and assemble the power plug, power adapter, and power terminal
according to local standards.
•
If the gNB and the power supply are both DC, assemble the plug according to the labels and
instructions on the plug.
24
Advertisement
Table of Contents
