Danfoss VLT AQUA Drive FC 202 Operating Manual page 7

Operating Guide | VLT® AQUA Drive FC 202
6.6 Parameter Settings
6.6.1 Parameter Setting Overview
6.6.2 Uploading and Downloading Parameter Settings
6.6.3 Restoring Factory Default Settings Using the Recommended Initialization
6.6.4 Restoring Factory Default Settings Using Manual Initialization
7 Wiring Configuration Examples
7.1 Application Examples
7.1.1 Wiring Configuration for Automatic Motor Adaptation (AMA)
7.1.2 Wiring Configuration for Automatic Motor Adaptation without T27
7.1.3 Wiring Configuration: Speed
7.1.4 Wiring Configuration: Feedback
7.1.5 Wiring Configuration: Run/Stop
7.1.6 Wiring Configuration: Start/Stop
7.1.7 Wiring Configuration: External Alarm Reset
7.1.8 Wiring Configuration: RS485
7.1.9 Wiring Configuration: Motor Thermistor
7.1.10 Wiring for Regen
7.1.11 Wiring Configuration for a Relay Setup with Smart Logic Control
7.1.12 Wiring Configuration for a Submersible Pump
7.1.13 Wiring Configuration for a Cascade Controller
7.1.14 Wiring Configuration for a Fixed Variable Speed Pump
7.1.15 Wiring Configuration for Lead Pump Alternation
8 Maintenance, Diagnostics, and Troubleshooting
8.1 Maintenance and Service
8.2 Heat Sink Service
8.2.1 Heat Sink Access Panel
8.2.2 Removing Dust Buildup from the Heat Sink
8.3 Status Messages
8.3.1 Status Message Overview
8.3.2 Status Messages - Operating Mode
8.3.3 Status Messages - Reference Site
8.3.4 Status Messages - Operation Status
8.4 Warnings and Alarms
8.5 Troubleshooting
9 Specifications
9.1 Electrical Data
9.1.1 Electrical Data, 380-480 V AC
9.1.2 Electrical Data, 525-690 V AC
9.2 Mains Supply
9.3 Motor Output and Torque Characteristics
Danfoss A/S © 2020.01
Contents
72
72
72
73
73
74
74
74
75
75
78
81
84
87
88
88
90
91
91
94
96
97
98
98
98
98
98
99
99
100
100
101
103
127
130
130
130
132
135
135
AQ275652274277en-000101 / | 5