Data Cable Rs232 Pc-Drive Controller; Usb-Serial Converter; Connection Of The Rs485 Interface; Remote Control - KEB COMBIVERT S6 Instructions For Use Manual

6 | Diagnosis/visualisation X4A
6.2 Data cable RS232 PC-Drive Controller
6.3 USB-serial converter
6.4 Connection of the RS485 interface
6.5 Remote control
28
1
6
9
5
Fig. 2: Serial cable for the connection to a PC
The USB serial converter (material number 0058060-0040) is used to connect
drive controllers, operators or IPC controllers with
terface to the USB port of personal computers. The USB-serial converter is intern-
ally electrically isolated.
The RS485 interface supports half-duplex and duplex operation. Wiring examples
can be found in the following link:
Wiring examples can be found under the following link:
(► https://www.keb.de/fileadmin/media/Techinfo/dr/
tn/ti_dr_tn-rs485-connection-00002_en.pdf)
The F6 operator with display/keypad can be operated up to 30 m away from the
unit.
Recommended connection:
• Commercially available network cable 1:1 with RJ45 plugs (min. CAT5)
• Install to both ends an RJ45 socket on D-SUB DE-9 (1x female; 1x male)
• Important! The shielding from X4A to the operator must be connected via the
CAT5 cable.
Signal
RxD-A
RxD-B
TxD-A
TxD-B
reserved
DGND
Shielding
Tab. 14: Wiring of the DE-9 - RJ45 adapters
KEB Automation KG
0058025-001D
DIN 66019
D-SUB DE-9 pin
4
5
8
9
6
7
Housing
ma_dr_s6-cu-p-inst-20156056_en
5
9
6
1
interface or HSP5 in-
RJ45 pin
1
2
4
5
3
6
Housing