Qualification; Order Data; Product Description - KEB COMBICOM Installation Manual

Use under spe-
cial conditions
1.3

Qualification

All work from the transport, to installation and start-up as well as maintenance may only be
done by qualified personnel (IEC 364 and/or CENELEC HD 384 and IEC-Report 664 and note
national safety regulations). According to this manual qualified staff means those who are able
to recognise and judge the possible dangers based on their technical training and experience
and those with knowledge of the relevant standards and who are familiar with the field of pow-
er transmission (VDE 0100, VDE 0160 (EN 50178), VDE 0113 (EN 60204) as well as those
who note the valid local regulations).
1.4

Order data

USB serial Converter
USB cable type A  type B, 3 m (included)
Adapter DSUB9 to RJ45
1.5

Product description

The USB serial converter is used for the connection of KEB inverters, operators or controls
with DIN66019 interface or interface HSP5 at the USB port of personal computers. It repre-
sents a virtual COM interface on PC side.
The USB serial converter is not a standard USB serial converter. It can be used exclusively
for the communication with KEB units with the interfaces specified above.The converter must
be plugged directly on the interface. A 0.2 m, 1:1 cable can be used as extension. Use adapt-
er DSUB9 to RJ45 (.00F50C0.-0020) to connect the HSP5 interface by RJ45 socket.
The used semiconductors and components of KEB are de-
veloped and dimensioned for the use in industrial products. If
the KEB COMBIVERT is used in machines, which work under
exceptional conditions or if essential functions, life-supporting
measures or an extraordinary safety step must be fulfilled,
the necessary reliability and security must be ensured by the
machine builder.
KEB electronics components contain dangerous voltages
which can cause death or serious injury. In operation, drive
Danger by converters, depending on their degree of protection, may have
high voltage live, uninsulated, and possibly also moving and hot surfaces.
Care should be taken to ensure correct and safe operation to
minimise risk to personnel and equipment.
Introduction
00F58060-0040
00F50C4-1030
00F50C0-0020
GB -5