Glossary - KEB COMBIVERT S6 Instructions For Use Manual

Glossary

Glossary
4W
4-Wire; is used in the field of network technology
for serial full duplex operation.
Application
The application is the intended use of the KEB
product.
Autonegotiation
Procedure for determining the max. transmission
speed.
BiSS
Open source real-time interface for sensors and
actuators.
CAN®
Serial bus system running protocols such as
CANopen, Devicenet or J1939. CAN is a re-
gistered trademark of the CAN in AUTOMATION -
International Users and Manufactures Group e.V.
COMBIVERT
Proper name for a KEB Drive Controller.
COMBIVIS
KEB start-up and parameterizing software.
Customer
The customer has purchased a product from KEB
and integrates the KEB product into his product
(customer product) or resells the KEB product (re-
seller).
DIN 66019
Information processing; control method with the 7-
bit code during data transmission.
DIN EN 61131-2
Programmable controllers - Part 2: Equipment re-
quirements and tests.
Directive 2006/42/EC
Machinery Directive
Directive 2014/30/EU
Electromagnetic Compatibility (EMC) Directive
44
EN 60204-1
Safety of machinery - Electrical equipment of ma-
chines - Part 1: General requirements (VDE
0113-1, IEC 44/709/CDV).
EN 61800-5-1
Adjustable speed electrical power drive systems.
Part 5-1: Safety requirements - Electrical, thermal
and energy requirements (VDE 0160-105-1, IEC
61800-5-1)
EnDat
Bidirectional encoder interface of the company
Heidenhain.
EtherCAT®
EtherCAT is a real-time Ethernet bus system.
EtherCAT is a registered trademark and patented
technology, licensed by Beckhoff Automation
GmbH, Germany.
Form A
IEC
NFPA
Form A describes a relay with two contacts
(switching contact and normally open contact).
Also referred to as SPST NO (single pole, single
throw; normally open).
Hiperface
Bidirectional encoder interface of the company
Sick-Stegmann.
HSP5
Fast, serial protocol.
HTL
Incremental signal with an output voltage (up to
30V) -> TTL.
ma_dr_s6-cu-p-inst-20156056_en
KEB Automation KG