Channels - Strong SRT 7501 User Manual

7.1.3.1 Edit, add or delete transponders
In this submenu, you can edit transponders. Use pq to navigate.
Frequency:
Symbol Rate:
Polarization:
Select pq Save to accept or Cancel to discard the changes.
If you have selected a specific transponder from the list and want to delete it, use the YELLOW key and
confirm the message with OK.
7.1.4 Factory Reset
The factory reset will set the receiver back to the default settings. All saved channels and settings will be
lost!
To reset the receiver, enter your PIN-Code(DEFAULT PIN-CODE: 0000). Use t u to select OK to perform
the reset or Cancel to return to the menu. After the factory reset the receiver will start within the First
Time Installation.
WARNING:

7.2 Channels

Press MENU and use t u to select the Channels menu. The following sub-menus are available: TV
Channel Manager, Radio Channel Manager, Electronic Programme Guide and Parental Control.
7.2.1 TV Channel Manager
This menu allows you to customize your channel list or create favourite lists. To perform the desired
action, proceed as described below.
On the upper left, you can see the preview of the currently selected channel. Below you can find the
selection of the various functions as well as FAV for creating favourite lists. In the middle is the empty
list where selected channels will be displayed. On the right, in the Program List you will see the channels
listed as in the standard channel list (depending on which one was selected during the First Time
Installation). Use pq to select a desired function and then u to go to Program List (except when
selecting FAV, see below). Then you will see that the selected option is dark grey. You can use P+/P- to
scroll through lists. ! and VOL+/VOL- are also available in this mode.
If you are in the Program List (right), you can select channels to be locked, deleted or moved by using OK.
These are listed in the centre under Selected. In this stage the receiver will switch to the selected channel
automatically which should make the allocation easier for you. If you have marked a channel by mistake,
move to the centre and press OK on the channel and the selection will be cancelled.
When using the Lock function, the selected channels are marked with the  after saving. Locked
channels are locked in all channel lists, the PIN-Code must be entered for viewing (DEFAULT PIN-CODE:
0000).
For the Delete function you can mark as much channels as you like and will only be asked to accept the
changes when leaving the menu through
16
Use the 0~9 buttons to enter the desired/changed frequency.
Use the 0~9 buttons to enter the required symbol rate.
Use the t u buttons to change the polarization.
A factory reset will permanently delete all your personal settings, channels
and timers. Please consider this before you perform a factory reset.
.