Main Menu; Installation - Strong SRT 7501 User Manual

The detailed description of the timer functions can be found in chapter 7.3.4 Timer.
NOTE:

7.0 MAIN MENU

Press MENU in viewing mode to display the main menu. All important settings and features of your
receiver can be operated from there. It consists of the following sub-menus: Installation, Channels,
Settings, Multimedia, Update and CA Menu.
Use t u to select a sub-menu and pq to choose an option. Press OK to open the chosen submenu.

7.1 Installation

Press MENU and select Installation with t u. The following sub-menus are available: Antenna Setup,
Motor Setting, Channel Search and Factory Reset.
7.1.1 Antenna Setup
In this menu, you can change and adapt settings for the antenna(s) and their transponders. Use the t u
buttons to change settings, and use pq to select an item, or press OK to list the settings. For the default
setting of DiSEqC 1.0, you can set the parameters for up to 4 satellite positions Port 1-4.
Satellite
LNB Power
LNB Type
LNB Freq
22 KHz Tone
DiSEqC 1.0
DiSEqC 1.1
Transponder
SatCR freq
SatCR ub
If Transponder is highlighted, the channel search can be started on this TP by using the RED Search
button or just press OK, the GREEN Auto DiSEqC Search* button allows you to search for available
satellites in the existing antenna installation.
* This function can find available satellites within the already persisting installation. The preconfigured satellites are: Astra 19.2E, Astra 23.5E,
Astra 28.2E, HotBird 13.0E and Eutelsat 9.0E.
Availability of EPG data depends on broadcast and can be displayed for up
to 7 days. If you are opening the EPG just after the receiver was switched
on or changed to another transponder we recommend to wait for a short
moment in order to collect the data.
Press OK to open the list of available satellites. Select the desired satellite with
pq or P+/P- and confirm with OK.
If necessary, you can change the LNB voltage using the t u buttons.
Select the desired LNB type using the t u buttons if you are not using a
universal LNB. Available are: C Band, SatCR and User defined.
Displays the corresponding values for the LNB type. 4 adjustments are
possible.
Not configurable at Universal LNB Type.
If DiSEqC 1.0 is used, up to 4 positions can be linked to satellites.
If DiSEqC 1.1 is used, up to 16 positions can be linked to satellites.
Press OK to open the list of available transponders for the selected satellite to
check the parameters or adjust the antenna.
When using SatCR LNB Type, this option appears to enter the desired
frequency.
When using SatCR LNB Type, this option appears to enter the desired ID
number.
13