Table of Contents
Advertisement
2.6 Inserting the batteries
NOTE:
2.7 Using the remote control
NOTE:
3.0 CONNECTIONS
3.1 Basic connection to the TV
a) Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good
quality coaxial cable and suitable 'F-connector' plugs.
b) Connect one end of a good quality HDMI cable to the HDMI connector of your receiver and the
other end to the HDMI input of your TV set.
c) Plug the power adapter jack to the receiver and the other end to a suitable wall outlet.
Optional: Connect one end of a good quality Scart cable to the TV SCART of your receiver and the other
end to the SCART input of your TV set.
3.2 Connecting to your home entertainment via coax S/PDIF
a) Connect your USB 2.0 storage device to this connector by using a good quality USB cable or
insert the device directly.
b) Connect one end of a good quality coaxial audio cable to the S/PDIF output of your receiver
and the other end to the coaxial audio input of your home theatre, amplifier or any other device
supporting digital audio.
c) Plug the power adapter jack to the receiver and the other end to a suitable wall outlet.
3.3 Connecting to your satellite dish via DiSEqC 1.0
a) Connect the LNBs of your fixed antenna to the desired inputs of a DiSEqC 1.0 switch using a
good quality coaxial cable and suitable 'F-connectors'.
b) Connect the output (or "to receiver") of the DiSEqC 1.0 switch to the SAT IN connector on your
receiver using a good quality coaxial cable and suitable 'F-connectors'.
c) Plug the power adapter jack to the receiver and the other end to a suitable wall outlet.
The batteries must not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
The remote control will not operate if its path is blocked or affected by
bright/stroboscopic light.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
7
Advertisement
Table of Contents
