Chapter 9 Setup Menu; Setup Menu; Radar Setup - Simrad CX34 Manual

Setup menu

9. Setup menu
RADAR
CHART
ECHO
PILOT
1
Speed alarm, units & language - see section 9.5
2
Interface setup
3
Palette setup
4
Factory settings
5
QuickGuide
*) available with built-in Echosounder function.

9.1 Radar setup

After the installation is completed, check the Radar setup to see
if the Scanner height is correct and the Heading adjust is zero
degrees to ship's center line. If not, then they need to be corrected -
see further ahead in this section. All default settings from the factory
are tested for various situations, however, if your situation is such
that adjustments are required, please refer to the details described in
this section. The Scanner type is preset to Auto detect and as such,
the system will automatically initiate the correct parameters for the
connected scanner.
MENU
Call up the menu bar, and...
activate the SETUP menu, and...
7
load the Radar setup - see example next page.
RADAR
You will now receive a warning that you are about to change settings
for the radar. Press [ENT] to Continue, or [MENU] to Abandon.
Use the cursor key to move around in the settings. Toggle between
available values with the +/- keys, and insert data by the numeric keys.
Confirm the adjustments by [ENT] or [MENU]
ENT
7
SETUP
Radar setup
C-MAP cartridges
Echosounder setup*
Pilot/Position setup
CX34/44/54 Operator manual
- see section 9.1
- see section 9.2
- see section 9.3
- see section 9.4
- see section 9.6
- see section 9.7
- see section 9.8
- see section 9.9
Chapter 9-1