Presentation Setup - Simrad CX34 Manual

Echo menu

5.7 Presentation setup

The general Echosounder setup e.g. Selecting transducer, Alarm set-
tings, Demo mode etc. is placed in the SETUP menu (section 9.3).
The echo setup in this chapter are the most common settings for
adjusting the presentation of the high or low frequency echo picture,
and can be accessed by a single keystroke.
Press [ADJ] from active echo display
ADJ
Setup 200kHz:
Range start:
Range:
Gain:
White line:
Expansion window:
TVG:
Ping to ping filter:
Signal threshold:
Color threshold:
Depth grid:
Transmit pulse length:
Transmit power:
Scroll synchronization:
Scroll speed:
Use the cursor key to move cursor around in the display
Key in new figures, or...
0-9
Toggle between available values
+/-
Confirm changes, or...
ENT
Abandon changes and exit display
MENU
Range start – allows the user to set the displayed depth range to
begin at some point below the surface. For example, a 100 meter dis-
played range can be "phased" downwards, so that the screen shows
a 100 meter section beginning at, say, 200 meters and going to 300
meters depth.
Range – refers to the distance shown from the top to the bottom of
the display screen. Selecting Auto range will cause the CX34/44/54
Normal (20 log R)
CX34/44/54 Operator manual
000 m
AUTO 25 m
050%
OFF
6 m
ON
OFF
OFF
OFF
AUTO
AUTO
TIME
HIGH
Chapter 5-7