Navigator Setup - Simrad CS66 Operator's Manual

Simrad CS66
Note
38

Navigator setup

Primary navigator sensor is selected from the drop down field
shown on the figure.
The vessel's position in the chart will always be shown at the
position received from the primary navigational source.
If the data received from this source is invalid or missing, the
CS will continue checking the data in a time-out period pre-
selected during installation. If valid data is not received within
this time, the CS will switch to secondary source if this is
activated.
Secondary source is selected if dual track is wanted, for check
of position difference between primary and secondary source,
and for selection of source to be used if the primary source is
lost.
If secondary source is not activated, the system will stop
updating position and give alarm if data from primary source is
lost. The vessel symbol will change to red color!
Manual input fields used for entering the vessel's latitudinal
and longitudinal Dead Reckoning position if no reference
systems are available.
Used for entering fixed offset values to be added to received
coordinates. When the Enable offset function is enabled,
selected offset value will be indicated in the NAV window.
Refer page 47.
Gyro
Gyro systems are configured during installation of the CS
system. Available names will be displayed in the Gyro drop
down field.
Used for manually entering heading value.
Permitted heading deviation between primary and secondary
heading source before an alarm is given.
Used for initializing correct ship heading.
Log
Speed log systems are configured during installation of the
CS66 system. Available names will be displayed in the Log
drop down field.
20221859 / F