Table of Contents
Advertisement
Radar-Assisted Event Enforcement Traffic Camera User Manual
DHCP
The device automatically gets the IP parameters from the network if you check DHCP. The
device IP address is changed after enabling the function. You can use SADP to get the
device IP address.
Note
The network that the device is connected to should support DHCP.
Manual
You can set the device IP parameters manually. Enter IP Address, Subnet Mask, and
Gateway.
IPv6
Three IPv6 modes are available.
Route Advertisement
The IPv6 address is generated by combining the route advertisement and the device Mac
address.
Note
Route advertisement mode requires the support from the router that the device is
connected to.
DHCP
The IPv6 address is assigned by the server, router, or gateway.
Manual
Enter IPv6 Address, IPv6 Subnet Mask, and IPv6 Gateway. Consult the network
administrator for required information.
MTU
It stands for maximum transmission unit. It is the size of the largest protocol data unit that
can be communicated in a single network layer transaction.
The valid value range of MTU is 1280 to 1500.
Multicast
Multicast is group communication where data transmission is addressed to a group of
destination devices simultaneously. After setting the IP address of the multicast host, you can
send the source data efficiently to multiple receivers.
Router
Enter Route Address and Subnet Mask if the device is connected to a router.
DNS
It stands for domain name server. It is required if you need to visit the device with domain
name. And it is also required for some applications (e.g., sending email). Set Preferred DNS
47
Advertisement
Table of Contents
