Table of Contents
Advertisement
Radar-Assisted Event Enforcement Traffic Camera User Manual
Chapter 8 Network Configuration
8.1 Set IP Address
IP address must be properly configured before you operate the device over network. IPv4 and IPv6
are both supported. Both versions can be configured simultaneously without conflicting to each
other.
Steps
1. Go to Configuration → Device Configuration → System → Network Interface Parameters.
2. Select Dual-NIC Mode.
3. Set the parameters below.
NIC Type
Select a NIC (Network Interface Card) type according to your network condition.
IP Address
Two modes are available.
Figure 8-1 Set IP Address
46
Advertisement
Table of Contents
