HIKVISION iDS-TCS907-CIR User Manual page 26

Radar-Assisted Event Enforcement Traffic Camera User Manual
The radar track of the target will be overlaid on the captured picture.
Close Range Capture
Check it and set Capture Interval. The device will track the target until one more picture is
captured in close distance according to the capture interval.
6. Check the event(s) to be detected, and set the corresponding parameters.
Sensitivity
The higher the sensitivity is, the more possibly the detected target will be judged as the
violation vehicle. If the value is too high, mistaken alarms may be triggered. If the value is too
low, there may be missing alarms. Set the value reasonably according to the actual needs.
Lowest Speed Limit
The allowable minimal speed of the vehicle.
Duration
When the selected event lasts for the set duration, the vehicle is judged as the violation
vehicle.
Linked Area
Check the lane area(s) to link to the corresponding events.
Congestion Duration
When the congestion duration exceeds the set value, the lane will be judged as congested.
Alarm Interval
The interval between two alarms.
Pedestrian Type
Check the pedestrian type(s) to be detected, including the walking pedestrian, the pedestrian
riding two wheeler or tricycle.
Capture Mode
Select Burst or Strobe for the checkpoint capture.
7. Set the lane parameters.
1) Click the lane No.
2) Select Linked Lane No.
3) Select Lane Direction Type.
4) Select Lane Type.
5) Select Flash Light Mode and Linkage Output.
6) Optional: Check lane(s) to copy the parameters of the current lane to other lane(s).
8. Draw the lane area.
1) Click Draw Area.
2) Select the lane.
3) Set the property of the lane lines and right border line.
4) Select the default lane lines and right border line, and drag the two end points of the line or
drag the whole line to adjust its position according to the actual scene.
15