Control Modes; One Performer (Stand-Alone); Multiple Performers (Master/Slave Control) - SHOWTEC 33036 Manual

Performer 2000 Fresnel DDT MKII

Control Modes

There are 3 modes:

One Performer (Stand-alone)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Performer is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 18-22 for more information.

Multiple Performers (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin/5-pin XLR cable to connect the Performer.
The pins:
03) Link the units as shown in fig. 06. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 18-22. This means that
you can set your desired operation mode on the master device and all slave devices will react the
same as the master device.
Multiple Performers (Master/Slave control)
Ordercode: 33036
• Stand-alone
• Master/Slave
• DMX-512 (1CH, 2CH, 5CH)
01) Earth
02) Signal -
03) Signal +
13
Fig. 06