Table of Contents
Advertisement
Stellar S-1200 Snow Machine
Put the fluid tank back in the device, as shown in Fig. 18.
Screw the lid back on the fluid tank, as shown in Fig. 19.
Notes:
Do not allow the snow liquid to become contaminated. Always replace the caps on the snow liquid
container and the snow machine liquid tank immediately after filling.
Restarting the Device after Running the Tank empty
When running a tank completely empty, the pump will automatically stop blowing snow to prevent
damage to the pump. The display will blink and show:
If you refill the tank and try to operate the device, the display will keep displaying this Warning
message.
Make sure you fill the entire tank and then manually start blowing snow.
This will take a few seconds until the completely emptied lines are filled with snow fluid.
Control Modes
The Stellar S-1200 Snow Machine supports the following control modes:
●
Manual (snow intensity/volume, duration, interval/timer)
●
Manual via Remote control
●
1, 3, 5 DMX channels
For more information about how to connect the devices, refer to 5. Setup on pages 18–20.
Product code: 61115
Fig. 18
24
Fig. 19
Advertisement
Table of Contents
