Refresh Rate; Calibration; Info - SHOWTEC 33036 Manual

Performer 2000 Fresnel DDT MKII

6.10. Refresh Rate

01) When the display shows PWM RATE, press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to toggle through the 5 options:
600Hz
1200Hz
2000Hz
4000Hz
25000Hz
Note:  When the refresh rate is increased, the gray scale dimmer rate will be reduced (that means
that the dimmer resolution will decrease when refresh rate is increased).
 When the PWM rate is 4000Hz, CURVE3 is invalid (see page 22).
 When the PWM rate is 25000Hz, CURVE1, CURVE2 and CURVE3 are invalid.
You need to decrease the PWM rate to increase the gray rate.

7. Calibration

With this menu, you can calibrate the device's color.
01) While in the main menu, press the UP/DOWN buttons to choose CALZ.
02) Press the ENTER button to open the menu.
03) Insert the password in order to access the menu. Press the buttons in the following order:
UP,DOWN,UP,DOWN and press the ENTER button to confirm.
04) You can choose between Pose1 or Pose2.
05) Press the ENTER button again to open the submenu.
06) Press the UP/DOWN buttons to choose between the desired option.
07) Press the ENTER button again to open the submenu.
08) Press the UP/DOWN buttons to set the desired option, the adjustment range is between 0-255.

8. Info

With this menu, you can obtain info about the device.
01) While in the main menu, press the UP/DOWN buttons to choose INFO
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to choose between Version or RDM protocol.
04) If you choose INFO, the software version and date will appear at the screen.
05) If you choose RDM, press the ENTER button again to open the submenu.
06) If you choose UID, you will see the device's code that will be sent to the RDM controller.
07) If you choose LABEL, you will see the device's name that will be sent to the RDM controller.
Ordercode: 33036
22