Table of Contents
Advertisement
Stardrape White LED WhiteCloth
Control Modes
There are 5 modes:
One Stardrape (Built-in programs and Full Mode)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Stardrape is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 15 and 16 for more information about the Built-in programs and Full Mode.
One Stardrape (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Stardrape will react to the beat of
the music. Please see page 16 for more information about the sound-control options.
Multiple Stardrapes (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Stardrape.
The pins:
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 15-16 (Built-in
programs, Full Mode or Sound-controlled Mode). This means that you can set your desired operation
mode on the master device and all slave devices will react the same as the master device.
However, the DMX address of the slave devices must be the same as the one of the master device.
Multiple Stardrapes (Master/Slave control)
Ordercode: 40461W
• Built-in programs
• Full Mode
• Sound-controlled
• Master/Slave
• DMX-512 (8CH)
01)
Earth
02)
Signal -
03)
Signal +
11
Fig. 03
Advertisement
Table of Contents
