Table of Contents
Advertisement
Installation
Remove all packing materials from the
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Control Modes
There are 4 modes:
One Indigo
(Built-in
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3. When the Indigo is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 18 for more information about the built-in programs.
One Indigo (Sound-control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
Turn on the music. If the device is set to sound-control, then the Indigo will react to the beat of the
music.
Please see page 18 for more information about the sound-control
Multiple Indigo's
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the Indigo.
The pins:
3.
Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 18 (Built-in Programs or
Music control). This means on the master device you can set your desired operation Mode and all
slave devices will react the same as the master device.
Indigo 5500
• Stand-alone (built-in programs)
• Sound-controlled
• Master/Slave
• DMX512 (14 Channels Person 1 or 11 Channels Person 2)
Programs)
(Master/Slave control)
1.
Earth
2.
Signal -
3.
Signal +
Multiple Indigo's
LED. Check that all foam and plastic padding is
(Master/Slave control)
9
options.
Fig. 3
Advertisement
Table of Contents
