Run Mode; Power Mode; Address; Motor Mode - SHOWTEC 33036 Manual

Performer 2000 Fresnel DDT MKII

2. Run Mode

In this mode you can set the desired operation mode.
01) While in main menu, press the UP/DOWN buttons until the display shows RUNMODE.
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle through the 4 options:
 DMX 512
 SLAVE
 DMMR
 SENS
04) When the display shows DMX 512, the Performer will become a master device and will utilize the DMX
protocol to determine its performance.
05) When the display shows SLAV, the Performer will become a slave device and will react the same as
the master device.
06) When the display shows DMMR and the Performer is connected to a triac, DMX will not function and
dimming will be possible only by means of your triac.
07) When the display shows SENS, two situations may occur:
 When the power supply reaches 80% of the nominal voltage and a DMX signal is received, the
Performer will be controlled by DMX.
 When the power supply is below 80% of the nominal voltage and there is not any DMX signal,
the Performer will switch to Triac mode.

3.Power Mode

In this mode you can set the desired power mode of the Performer.
01) While in main menu, press the UP/DOWN buttons until the display shows POWERMODE.
02) Press the ENTER button to open the menu.
03) Choose the desired power mode, you can choose between 575W or 750W.

4. Address

With this menu you can set the desired DMX starting address.
01) Press the UP/DOWN buttons to set the desired DMX starting address. The adjustment range is
between 001-512.

5. Motor Mode

In this mode you can turn of the motor of the Performer.
01) While in main menu, press the UP/DOWN buttons until the display shows MOTOR.
02) Press the ENTER button to open the menu.
03) Choose the desired option, you can choose between YES or NO.
Ordercode: 33036
19