Chapter 7 Etherchannel Commands; Channel-Group - TP-Link JetStream TL-SL3452 Reference Manual

Chapter 7
Etherchannel Commands are used to configure LAG and LACP function.
LAG (Link Aggregation Group) is to combine a number of ports together to make a single
high-bandwidth data path, which can highly extend the bandwidth. The bandwidth of the LAG is
the sum of bandwidth of its member port.
LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link
aggregation and disaggregation by exchanging LACP packets with its partner. The switch can
dynamically group similarly configured ports into a single logical link, which will highly extend the
bandwidth and flexibly balance the load.

channel-group

Description
The channel-group command is used to add a port to the EtherChannel Group
and configure its mode. To delete the port from the EtherChannel Group, please
use no channel-group command.
Syntax
channel-group num mode { on | active | passive }
no channel-group
Parameter
num —— The number of the EtherChannel Group, ranging from 1 to 14.
on —— Enable the static LAG.
active —— Enable the active LACP mode.
passive —— Enable the passive LACP mode.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEhternet)
Example
Add the Fast Ethernet port 2-4 to EtherChannel Group 1 and enable the static
LAG:
TL-SL3428(config)#interface range fastEthernet 1/0/2-4
TL-SL3428(config-if-range)#channel-group 1 mode on
TL-SL3428/TL-SL3452
Etherchannel Commands
JetStream L2 Managed Switch CLI Guide
37