2.6.2
Cable Crossing
In case communication cable must cross power lines, this should always take place
at right angle (90 degrees). Do not place them in the same direction (parallel). This is
shown in Figure 2.14.
Figure 2.14 Communication cable and power cable crossing
2.6.3
Avoid Cable Loop
Coils in the communication cables should be avoided, as they represent large areas
where electromagnetic disturbances can be introduced into the network and severely
affect the communication performances as shown in Figure 2.15.
Figure 2.15 Avoid loops in communication cables
13
AMAX-5000 Series User Manual