Table of Contents
Advertisement
NOTE:
4.0 STARTING UP FOR THE FIRST TIME
If you use your receiver for the first time, the Installation Guide menu appears. Use pq to move the
highlight to the setting you wish to change and use t u to change values. Start by selecting your
On-Screen Language (OSD) using t u. Once you have selected your language, press q to move the
highlight to Country. Select your country using t u.
Other options are:
Antenna Power:
Scan mode:
Once all settings are made, move the highlight to Channel Search and press OK to start scanning.
The receiver will now search for all available channels. Once scanning is finished, the receiver switches
to viewing mode.
NOTE:
TIP:
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the pq buttons. Alternatively, you can digit the channel number
with the 0~9 buttons on the remote control. Or press OK in viewing mode to display the channel list.
The volume can be adjusted with the t u buttons.
Default Password is 1234.
Because of the Twin-Tuner technology, you can record one channel and watch another at the same
time, even on a different frequency.
This output does not carry the signal from the unit itself.
Set to On if you use an active antenna. When set to On, a 5 Volt power will
be present on the RF IN connector of the receiver. Select Off for passive
antennas.
Select All to store scrambled and free to air channels or select FTA to store
only Free-To-Air channels. Note: Scrambled channels you cannot watch with
this receiver.
Selecting the wrong country may result in a disorderly channel list, and
missing of channels.
In case the Installation Guide menu does not appear after switching on the
receiver the first time, reset the receiver to factory settings by pressing the
MENU button and selecting Restore Factory Default in submenu System.
(Default PIN 1234)
9
Advertisement
Table of Contents
