Table of Contents
Advertisement
NOTE:
Timeshift/recording and playback only works properly when a fast USB storage device such
as a USB 2.0 HDD is connected to the receiver. Timeshift/recording and playback of HD
content requires a sufficient continuous read/write speed of the used USB storage device. *
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.
4.0 STARTING UP FOR THE FIRST TIME
When you use your receiver for the first time, the Welcome menu appears. Use pq to move the highlight to the setting
you wish to alter and use t u to change values. Start by selecting your language using t u. Once you have selected
your language, press q to move the highlight to the next item and use t u to change.
Language
Here you can choose your language.
Region:
Select your region where this receiver is used.
Subtitle:
Select Normal to display subtitles per default, Select Hard of Hearing to show HoH subtitles per
default. Select Off to hide subtitles per default. *
Aspect Mode:
Use this option to select the aspect ratio of your TV and the preferred conversion method. The
options are: Auto (automatic detection of aspect ratio), 4:3 Panscan (Displays 16:9 widescreen
broadcasts full screen on your 4:3 TV), 4:3 letterbox (black bars on top and under the picture on
a 4:3 TV) and 16:9 (use this setting for 16:9 TV sets).
Scan mode:
Select All to store scrambled and free to air channels or select Free to store only free to air
channels. Note: Scrambled channels cannot be viewed with this receiver.
Connection:
Use this option to adjust the established connection to your TV set. Select HDMI or TV SCART.
* Availability of DVB/HoH subtitles depends on the broadcast. If subtitles are not supported, they can be activated via Teletext if available.
When all settings have been made, move the highlight to OK and press OK to continue.
NOTE:
Wrong region selection can lead to missing channels or channels being stored at wrong
positions in the channel list.
4.1 DVB-C Installation
Select Installation and press OK to enter the installation menu. Press pq t u to select Channel Scan or Auto Scan.
4.1.1 Channel Scan
Select Channel Scan and press OK to enter the Channel Scan menu. Press pq t u to set Scan mode, Channel No.,
Frequency, Symbol Rate, Scan QAM and Network Search. Highlight Search and press Ok to start the channel scan. Obtain
technical data about your cable operator's base channel from your operator and start a Network search from there to
find all channels belonging to the network.
4.1.2 Auto Scan
Select Auto Scan and press OK to enter the Auto Scan menu. Press pq t u to set Country and Network and then
highlight Search. Press OK to start the auto search.
Some operators in Germany are pre-installed.
4.1.3 LCN
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the operator, channels will be
stored in an operator defined order. Set LCN to On to activate the operator defined channel numbering or Off to store
channels in the found order. This function only applies when a new channel search is performed.
7
Advertisement
Table of Contents
