Table of Contents
Advertisement
English
3.3 Basic connection using an HDMI cable
1. Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good
quality coaxial cable and suitable 'F-connector' plugs.
2. Connect one end of a good quality HDMI cable to the HDMI output on your receiver and the
other end to the HDMI input of your TV.
3. Plug the power adapter to a suitable wall outlet.
3.4 Basic connection using a SCART cable
1. Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good
quality coax cable and suitable 'F-connector' plugs.
2. Connect one end of a good quality Scart cable to the TV SCART connector on your receiver and
the other end to the SCART input of your TV.
3. Plug the power adapter to a suitable wall outlet.
3.5 Connecting to the Internet
The receiver connects to the Internet through the Internet router or DSL/cable modem in your home network.
It connects to the home network over its Ethernet port or Wi-Fi.
Connect one end of the Ethernet cable to the receiver and the other end to the LAN port at the router or DSL/
cable modem. To connect the receiver through Wi-Fi, set it during the First Time Installation or select Network
then WiFi Network in the main menu.
3.6 Connection to main power supply
After all the connections are done you can connect your receiver to power using the supplied external AC/DC
adapter. Now plug the adapter into the wall socket.
4.0 STARTING UP FOR THE FIRST TIME
Once you properly installed and connected all cables of the receiver, setup your receiver step by step by First
Time Installation procedure.
It will guide you through the basic installation and channel searching process.
4.1 Language, audio and video
The receiver turns on displaying the Welcome message, press OK to go to the next step. In this page it is
possible to set Language, Resolution, Aspect Ratio and Audio Format. Press OK to select the option you need to
change then p q to change selection. To confirm and exit press OK.
4.2 PIN code creation
Create and confirm the PIN code, then select AVANTI and confirm with OK to continue.
4.3 Internet Connection
If the Ethernet cable has already been connected, the receiver will display Connesso on Connessione Ethernet, if
not the receiver will display Collega il cavo. In this case connect the Ethernet cable to the Ethernet port and the
receiver will detect the connection automatically.
If you intend to connect the receiver via Wi-Fi connection, select Elenco reti and the receiver will display a list of
all available networks. Select your network by pressing OK and insert the password.
To go to the next step, select Avanti and confirm with OK.
Fig. 9
Fig. 9
Fig. 10
Fig. 10
9
Advertisement
Table of Contents
