Speaker Enable/Disable; Fan Detection Select; Chassis/Overheat Fan Select; Watch Dog Enable - Supermicro SUPERSERVER 6023L-8R User Manual

S
UPERSERVER 6023L-8R User's Manual

Speaker Enable/Disable

To disable the onboard speaker,
remove the jumper from JP2 (see
the table on the right).

Fan Detection Select

JP58 allows you to select which fan
speed to have displayed in the Hard-
ware Monitors section of BIOS (the
CPU1/2 fans or the CPU1/CPU2 Chassis
fans). The default position is open to
select the CPU1/2 fans. See the table on
the right for jumper settings.

Chassis/Overheat Fan Select

JP48 allows you to select to use ei-
ther the chassis fan or the overheat
fan. The default position is closed to
select the chassis fan. See the table
on the right for jumper settings.
Watch Dog
JP3 controls the Watch Dog function.
Watch Dog is a system monitor that
takes action when a software appli-
cation freezes the system.
will have WD reset the system if a
program freezes. Pins 2-3 will gener-
ate a non-maskable interrupt for the
program that has frozen (requires
software implementation).
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS.
Pins 1-2
See the
5-22
Speaker Enable/Disable
Jumper Settings
(JP2)
Fan Detection Select
Jumper
Jumper Settings (JP58)
Position Definition
Closed Enabled
Jumper
Open Disabled
Position Definition
Open CPU1/2 Fans
Closed CPU1/2 Ch Fans
Chassis/Overheat Fan
Select Jumper Settings
(JP48)
Jumper
Position Definition
Open Overheat Fan
Closed Chassis Fan
W atch Dog
Jumper Settings (JP3)
Jumper
Position Definition
Pins 1-2 W D to Reset
Pins 2-3 W D to NMI
Open Disabled