Table of Contents
Advertisement
Speaker Enable/Disable
You may want to disable the
onboard speaker.
gives you this option.
5-24 for jumper settings.
Onboard LAN/NIC
Enable/Disable
Change the setting of jumper JP58
to enable or disable the onboard
LAN or NIC (Network Interface
Card) on your motherboard.
Table 5-25 for jumper settings.
Third Power Supply Failure
Alarm Enable/Disable
(*For Supermicro's Hot-
Swap Triple Redundant
Power Supplies only)
The system will notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis, with one acting as a
backup. If you only have one or
two power supply units installed,
you should disable this with JP55
to prevent false alarms.
Table 5-26 for jumper settings.
Jumper JP56
See Table
See
See
5-21
Chapter 5: Installation
T a b le 5 -2 4
S p e a k e r E n a b le /D is a b le
J u m p e r S e tting s (J P 5 6 )
Jumper
Position
D efinition
O pen
D isabled
C losed
Enabled
T a b le 5 -2 5
O n b o a rd L A N /N IC
E n a b le /D is a b le
J u m p e r S e ttin g s (J P 5 8 )
Jumper
Position
D efinition
O pen
Enabled
C losed
D isabled
T a b le 5 -2 6
P o w e r S u p p ly F a ilu re
A la rm E n a b le/D is a b le
J u m p e r S e tting s (J P 5 5 )
Jumper
D efinition
Position
O pen
D isabled
C losed
Enabled
Advertisement
Table of Contents
