Input/Output Ports - Supermicro A+ Server AS-1115CS-TNR User Manual

4.3 Input/Output Ports

See Figure 4-2 below for the locations and descriptions of the various I/O ports on the rear
of the motherboard.
1
#
1
2
3
1. VGA Port
There is one VGA port on the rear I/O panel.
2. IPMI LAN Port
One dedicated IPMI LAN port is located on the rear I/O panel. This port accepts an RJ45
type cable.
3. Universal Serial Bus (USB) Ports
There are two USB 3.0 ports on the rear I/O panel. These support the type A connector.
4. COM Port
One serial communications (COM) port is included on the rear I/O panel.
5. UID Switch & UID LED
A Unit Identifier (UID SW) switch and UID LED (LED8) are located on the I/O backpanel. The
rear UID LED (LED8) is located next to the UID switch. When you press the UID switch, both
rear and front UID LED indicators will turn on. Press the UID switch again to turn off the LED
indicators. The UID Indicator provides easy identification of a system that may be in need of
service. See 2.6 for the front panel UID LED header location on JF1.
Note: UID can also be triggered via IPMI on the serverboard. For more information on IPMI,
please refer to the IPMI User's Guide posted on our website at
2
3
3
Figure 4-2. I/O Port Locations and Definitions
Rear I/O Ports
Description
VGA Port
IPMI LAN Port
USB Ports (USB 3.0)
Chapter 4: Motherboard Connections
4
# Description
4 COM Port
5
UID Switch & UID LED
http://www.supermicro.com
60
5