Using The Document Glass To Send A Fax In Direct Transmission Mode - Sharp DX-C311 Operation Manual

USING THE DOCUMENT GLASS TO SEND A FAX IN
DIRECT TRANSMISSION MODE
When sending a fax from the document glass in direct transmission mode, only one page can be transmitted.
1
Do not place any objects under the original size detector. Closing the automatic document feeder with an object
underneath may damage the original size detector plate and prevent correct detection of the document size.
(3)
5 10 15
To
Condition
Settings
AAA AAA
Address Review
CCC CCC
Address Entry
EEE EEE
Global
GGG GGG
Address Search
Sub Address III III
2
Freq.
Sort Address
• Only one destination can be entered. A one-touch key in which multiple destinations are stored (group key) cannot
be used.
• In addition to specification by one-touch key, a destination can also be specified using a search number. You can
also directly enter a fax number with the numeric keys or look up a destination in a global address book. For more
information, see
(2)
Cc
BBB BBB
DDD DDD
FFF FFF
HHH HHH
JJJ JJJ
ABCD EFGH IJKL MNOP QRSTU VWXYZ
Auto Reception
Fax Memory:100%
"ENTERING DESTINATIONS" (page 4-16).
Open the automatic document feeder,
place the original face down on the
document glass, and then gently close
the automatic document feeder.
Document glass scale
mark
5-1/2" x 8-1/2"
(A5)
8-1/2" x 11" (A4)
• Align the middle of the original with the tip of the
the middle of the scale on the left side of the document glass.
• Place the original in the appropriate position for its size as
shown above.
• When the original is a different size than the size setting, set
the original size.
☞
SPECIFYING THE SCAN SIZE AND SEND SIZE
4-45)
Enter the destination fax number.
(1) Touch the [Address Book] key in the base
screen.
1
For the [Address Book] key, see
2
FAX MODE" (page 4-8).
(2) Touch the one-touch key of the desired
destination.
etc. (3) Touch the [Condition Settings] key.
4-34
FACSIMILE
B5
"BASE SCREEN OF
Contents
mark at
(page