Specifying The Send Size Of The Image - Sharp DX-C311 Operation Manual

Specifying the send size of the image

Specify the send size as a paper size. If a send size bigger than the scan size is selected, the image will be enlarged. If
a send size smaller than the scan size is selected, the image will be reduced.
• The send size cannot be specified when [Long Size] is selected for the scan size, or when the scan size is specified by
numerical values.
• The send size cannot be specified when [TIFF-S] is selected for the format in Internet fax mode. (The send size is fixed at
8-1/2" x 11" (A4 in landscape orientation).)
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
1
(2) Touch the [Original] key.
☞
IMAGE SETTINGS
Scan/Original
Scan Size
8½x11
2
2-Sided 2-Sided
Booklet Tablet
Scan/Original
Auto
Manual
5½x8½ 8½x13
8½x11
8½x14
3
8½x13 11x17
• Depending on the paper size specified for the "Scan Size", it may not be possible to select some sizes for the "Send
Size". Size keys that cannot be specified for the "Send Size" are grayed out to prevent selection.
• To specify an AB size for the send size, touch the [AB
send size.
(page 5-49)
OK
100% Send Size
Auto
Image Orientation
(1) (2)
OK
AB
Inch
Touch the [Send Size] key.
Specify the send size.
(1) Touch the desired send size key.
(2) Touch the [OK] key.
Inch] key to highlight the [AB] side and then specify the
5-55
SCANNER/INTERNET FAX
Contents